Aller au contenu

CPFE033

IP over IPX n'a pas été activé.

IP over IPX not activated.

Gravité 40 · Fin anormale du programme ou de la fonction

Cause

Des erreurs se sont produites lors de l'activation de la prise en charge IP over IPX et ont empêché son activation. L'activation de la prise en charge IP over IPX a été tentée à la suite de l'un des événements suivants :

  • La commande CL Démarrage d'IPX (STRIPX) a été lancée.
  • La commande CL Modification des attributs réseau (CHGNETA) a été lancée avec le paramètre d'autorisation de la prise en charge AnyNet (ALWANYNET) défini à *YES.

Errors occurred while activating IP over IPX support that prevented it from being activated. Activating IP over IPX support was attempted as a result of one of the following: -- The Start IPX (STRIPX) CL command was issued. -- The Change Network Attributes (CHGNETA) CL command was issued with the allow AnyNet support (ALWANYNET parameter) set to *YES.

Que faire

Effectuez l'une des opérations suivantes :

  • Consultez les messages précédemment répertoriés dans l'historique de ce travail. Corrigez les erreurs, puis essayez de nouveau d'activer la prise en charge IP over IPX en lançant la commande CL Fin d'IPX (ENDIPX), puis la commande CL Démarrage d'IPX (STRIPX).
  • Consultez les messages précédemment répertoriés dans l'historique du travail QLUS. Pour afficher l'historique du travail QLUS, lancez la commande CL Gestion de travail (WRKJOB) en définissant le nom du travail (paramètre JOB) à QLUS. Repérez dans la liste l'entrée du travail QLUS dont l'état est actif. Entrez ensuite l'option 1=Sélectionner. Corrigez les erreurs, puis essayez de nouveau d'activer la prise en charge IP over IPX en lançant la commande CL CHGNETA avec ALWANYNET défini à *NO, puis en la relançant avec ALWANYNET défini à *YES.

Do one of the following: -- See the previously listed messages in the job log of this job. Correct the errors and then try activating the IP over IPX support again by issuing the End IPX (ENDIPX) CL command and then the Start IPX (STRIPX) CL command. -- See the previously listed messages in the QLUS job log. To view the QLUS job log, issue the Work with Job (WRKJOB) CL command with the job name (JOB parameter) set to QLUS. Locate the QLUS job entry with a status of active in the list. Then enter option 1=Select. Correct the errors and then try activating the IP over IPX support again by issuing the CHGNETA CL command with ALWANYNET set to *NO and then issue the command again with ALWANYNET set to *YES.

Sur votre IBM i

Afficher la description complète du message :

DSPMSGD RANGE(CPFE033) MSGF(QSYS/QCPFMSG)

L'intercepter dans un programme CL, quand il est envoyé comme message d'échappement :

MONMSG MSGID(CPFE033) EXEC(DO)
  /* traitement de l'erreur */
ENDDO